Article CEM sept. 2024

News in “Contrôles Essais Mesures”

Aérométrologie has communicated in the September 2024 issue of Contrôles Essais Mesures (CEM) in the “news” section. The article cited refers to our gas flow accreditation extension nr 2-1294 concerning the calibration of Molblocs with an extended uncertainty up to 0.1%, within the ra...
Read More
Plus petite des trois cuves PvTt

Gas flow calibration in air

The COFRAC audit from end of 2023, regarding the scope nr 2-1294, enabled Aérométrologie to position itself at the level of the best reference laboratories on the air flow meter calibration on the range of 1,94 mg.min-1 < qm  < 38,8 g.min-1 This extension of our accreditation has a dual obj...
Read More

Ilac-MRA brand

Aérométrologie has since 19/12/2023 the agreement to use the ILAC MRA brand for all its activities carried out under COFRAC accreditation. Why would we want such an agreement to use the ILAC MRA brand? The answer can be found in this extract from the web site https://ilac.org/about-ilac/ (that ref...
Read More

Doubled gas flow calibration capacity

Aérométrologie pursued its investment policy intended to reduce the calibration duration and to bring an answer adapted to your needs for services on any gas flow meter. Covered range So, VEDENE sees its COFRAC accreditation n°2-1931 for the gas flowmeter strengthened by this extension which doub...
Read More

COFRAC extension in pressure in Vedène

News on Vedène site In pressure The COFRAC just confirmed the extension in pressure under the number 2-1771 in Vedène. This extension in pressure allows now the calibration of manometers / transmitters in Vedène on the following ranges, in parallel to Les Ulis accreditation: Differential pressure...
Read More

COFRAC calibrations for blower doors fan and gauge

Since 2015 and in order to improve our services, Aérométrologie proposes COFRAC calibrations for blower doors fans and manometers. They are used for air building tightness testing, as well as ducts leakage testing. All our services are based on the appliance of the guide FD P50-784 and of the norm...
Read More

Shorter calibration time in anemometry

Since July 2016, Aérométrologie owns two blowers COFRAC accredited. Driven by our will to improve the customer service, we are now able to propose a calibration time reduced in anemometry, as well as an enlargement of the covered air speed. Precision on the calibration time Aérométrologie has a ...
Read More